Are You Walking Past Nuggets?

Are You Walking Past Nuggets?

By William Southern

Are you leaving nuggets and digging trash? I know that early on in my newby days I was! What was the reason? I just was not digging targets that my detector was telling me were there. The worst part was that I was digging plenty of trash! What the heck is going on? I am finding bullets, nails, tacks, bits of iron, and wire, but no gold nuggets. Sound like you? Read on....

The reason I went through this was that I was listening for that nice clear zip-zip of a target a VLF detector will give you and ignoring the odd sounding targets as being hot rocks or just ground noise Yes some were ground noise , but others were nuggets. Sooner or later even I wake up and I began checking out some of those "funny sounds" and yes indeed they were targets and some were gold nuggets!

Then after learning to investigate all signals as suspect until I see otherwise, I began seeing my finds increase tenfold. I was listening for one sound only all that time and walking right past gold. Now a surface nugget will give you a sharp clear signal, but a deep or small nugget will often do no more than slightly disturb the threshold. These disturbances can be very subtle and often take much concentration by the operator to even be noticed at all.

Jim Straight was a big help to me early on in my hunting days do to the fact he stresses making a target test area and learning your machine along with bench testing. I began then and still do this when I try out a new detector and it really helps you get to know your detector inside and out! I still consider Jim's books to be a very valuable learning tool for the nugget shooter and I recommend them!

Now enter the PI detector and it's already legendary ability to find gold, but talk about really having to be aware of small differences in threshold Sometimes no more than a groan can mean a target! Moving fast is out if you want to find gold on a regular basis because by doing so you will miss a very large percentage of the faint targets. Threshold instability is directly related to faster coil movement so you tend to not even notice what could be a signal. These detectors are a bit more involved, but once mastered is a unequaled tool in the gold fields.

The mono coils are much more tolerant of the quicker swing, but the DD coils work much better for me when I move slooooooow..... Now could that be why some of these guys can go to a pounded area and still find gold when you have been there 10 times without a nugget? YES that very well could be the reason. Having the coil to high is another big problem for many and add that to moving too fast and you have a problem. If you are not rubbing the ground a bit you will again be missing nuggets. After all a coil cover is not costly and the closer to the ground you hunt the more depth you acheve, simple math.

Ever see the guy that doesn't seem to get out of a small area for hours when you have already covered two washes and a flat without getting anything but bullets and boot tacks. When you ask how he's doing he shows you a couple nuggets I am not trying to be a smart ass here, but I like to say work your detector don't walk your detector. If you already know there is gold in the area slow down and find some of it.

So basically all I am getting at here is to get to know your detector and the sounds it makes and always investigate anything that just doesn't sound right because something is making the detector act that way and it very well could be a nugget! The sad truth is that many of the clear crisp targets will be in the trash bag..... Just a few lessons learned the hard way.

Back To: NUGGET-SHOOTER HOME